liposuction JNZB-A equipment

Description:

only need about 50 minutes
save 60% phsical force
small blood loss and less injury,
the postoperative parts are very even

1  Work principle: pneumatic handle works in low frequency(notstrenuous                   resonance) and in four directions  to break the fat and drawsthem out  of the body  

2  Use less energy than resonance and save 60% physicalforce, only need 50 minitues .Up to 10-12 parts at one time, Bigvolume; the ratio of water and fat is 1:3

3  The postoperative parts are very even due to thesectorial motion.

4 Small blood loss and less injury(the handle can easy destroythe fat and protect the  non-fat organization effectively dueto the special vibrating way (cyclone pneumatic passage)

5 There is no need to analgetic for the light pain after theoperation.Short recovery period

6    No electric element, no electromag-neticradiation and no heat; it wont hurt body; high temperature andpress sterilization is available.

7   Pneumatic handle has s long useful life for itworks in the way of piston,  not be easily damaged.

 

Technical Parameters : 

 

Dimensions		400 x 420 x 1020 mm
Net Weight		22 Kgs
Power		AC220V ±22V
Input Power		350 Watts
Voltage Control		DC24V
Noise		≤45db
Aspirator	Vaccum Accuracy	≥0.094 mpa
	Air Pumping Velocity	160 l/min
Pneumatic Handle Motion	Vibration Frequency	10 Hz
	Elongation	6 mm
Infiltration System	Speed	0-300 rpm
	Flux	1140 ml/min
Operation Mode	User-friendly	Soft Button Control Panel

liposuction JNZB-A equipment